guides:virtual_modem:section_4
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
guides:virtual_modem:section_4 [2019-02-18 03:13] omolini [Making Virtual Modem run at startup] |
guides:virtual_modem:section_4 [2019-02-18 04:14] omolini [Required packages] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Section 4 - Setting up Virtual Modem ====== | ====== Section 4 - Setting up Virtual Modem ====== | ||
| ==== Required packages ==== | ==== Required packages ==== | ||
| - | * For the connection script to work properly, your Raspbian installation needs a few prerequisite packages. The most important of these is the PPP daemon "pppd" and IP Tables to route packages. | + | For the connection script to work properly, your Raspbian installation needs a few prerequisite packages. The most important of these is the PPP daemon **"pppd"** and **IP Tables** to route packages. |
| * Run the following commands to install pppd and iptables: | * Run the following commands to install pppd and iptables: | ||
| <code bash> | <code bash> | ||
| Line 93: | Line 93: | ||
| - | * To restart the Raspberry and test the changes, issue the following command: | + | * Restart Raspberry and test the changes. After rebooting, VModem should automatically start up with system processes and start expecting connections on serial. |
| - | <code bash> | + | |
| - | sudo shutdown -r now | + | |
| - | </code> | + | |
| - | * After the Raspberry Pi boots, VModem should automatically start up with the system and start expecting connections on serial. | + | |
| ==== Skip to other sections ==== | ==== Skip to other sections ==== | ||
guides/virtual_modem/section_4.txt · Last modified: 2023-11-24 23:16 by omolini
Page Tools
